编了个内核,启动不了?
uboot 1.1.4 (Oct 19 2006 - 21:50:33)MPC8272 Reset Status: External Soft, External Hard
MPC8272 Clock Configuration
- Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq25-75 , Core Freq 100-300
- dfbrg 1, corecnf 0x1a, busdf 3, cpmdf 1, plldf 0, pllmf 3, pcidf 5
- vco_out400000000, scc_clk100000000, brg_clk 25000000
- cpu_clk400000000, cpm_clk200000000, bus_clk100000000
- pci_clk 66666666
CPU: MPC8272 (HiP7 Rev 14, Mask 1.0 1K50M) at 400 MHz
Board: Motorola MPC8272ADS
DRAM:128 MB
FLASH: 16 MB
001716f48000040000
In: serial
Out: serial
Err: serial
Net: FCC1 ETHERNET
Hit any key to stop autoboot:0
## Booting image at fe100000 ...
Image Name: mpc8272 2.4.22 linux
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 906037 Bytes = 884.8 kB
Load Address: 00000000
Entry Point:00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
## Loading RAMDisk Image at fe300000 ...
Image Name: PowerPC GLIBC Ramdisk Image
Image Type: PowerPC Linux RAMDisk Image (gzip compressed)
Data Size: 3008923 Bytes =2.9 MB
Load Address: 00000000
Entry Point:00000000
Verifying Checksum ... OK
Loading Ramdisk to 078c1000, end 07b9f99b ... OK
然后目标板挂了......
页:
[1]