mzyemail 发表于 2005-4-28 18:46:34

刚才那贴多余内容太多，重发

lspci -v 列出了相关设备，其中偶的网卡如下：
00:0d.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M (rev 78)
      Subsystem: Unknown device 17f2:4c00
      Flags: bus master, medium devsel, latency 32, IRQ 11
      I/O ports at b400
      Memory at e7102000 (32-bit, non-prefetchable)
      Capabilities: Power Management version 2

00:0c.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
      Subsystem: Realtek Semiconductor Co., Ltd. RT8139
      Flags: bus master, medium devsel, latency 32, IRQ 10
      I/O ports at b000
      Memory at e7100000 (32-bit, non-prefetchable)
      Capabilities: Power Management version 2


但是用ifconfig的结果是：
# ifconfig
eth1      Link encap:EthernetHWaddr 00:E0:4C:3B:A0:DD
          inet addr:192.168.18.102Bcast:192.168.18.255Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICASTMTU:1500Metric:1
          RX packets:3 errors:0 dropped:0 overruns:0 frame:0
          TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1240 (1.2 Kb)TX bytes:3394 (3.3 Kb)
          Interrupt:10 Base address:0x4000

lo      Link encap:Local Loopback
          inet addr:127.0.0.1Mask:255.0.0.0
          UP LOOPBACK RUNNINGMTU:16436Metric:1
          RX packets:6 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:300 (300.0 b)TX bytes:300 (300.0 b)

eth0不起作用, why??

mzyemail 发表于 2005-4-28 18:50:22

为什么eth0认得了却不起作用？请教斑竹了，谢谢谢谢
页: [1]
查看完整版本: 刚才那贴多余内容太多，重发