移植后的zhaoic的usb驱动程序安装过程
安装和运行详细过程如下:(1)先把lumit4510的串口uart0连接到主机的com1或com2上.
(2)打开主机的超级终端,与lumit4510连接(设置见实验手册).
出来如下信息:
/*************************************************************/
Bios for download and program.
Author Jerry
Build date : Oct 11 2004 Time : 22:20:11
Type help for help.
/*************************************************************/
(3)运行dn命令
\>dn
ev-7t bootloader download
No begin address for download, use default address 0x8000
Ready to download. Use 'transmit' option on terminal emulator to download file.
(4)把testusb.uue通过文本文件方式传输到lumit4510上.
然后终端出现如下信息:
Loaded file testusb.bin at address 8000, size = 8124
(5)运行命令go
\>go
go at address 0x8000
D12 chip ID:1210
PDIUSBD12 TEST
Pdiusbd12 Found, chip id = 0x1210
Please connect USB Line from PC to the Board
run LEDDEMO.EXE in the PC and Test
D12SuspChgProc
(6)根据上面提示:把usb连线先连接lumit4510,再然后连到主机的usb接口上.
(7)这时,终端显示如下信息:
D12Ep0IntProc
D12Ep1IntProc
D12Ep0IntProc
D12Ep1IntProc
D12BusRstProc
D12Ep0IntProc
D12Ep1IntProc
D12Ep0IntProc
D12Ep1IntProc
D12Ep0IntProc
D12Ep1IntProc
D12Ep1IntProc
D12Ep0IntProc
D12Ep1IntProc
D12Ep0IntProc
D12Ep1IntProc
D12Ep0IntProc
D12Ep1IntProc
D12Ep0IntProc
Device attached!
D12Ep1IntProc
(8)而主机端则显示要用户提供D12TEST.sys文件信息,
用户选择文件D12TEST.sys即可.
(注1:zhaoic说过目录不能太深,可能斑竹是安装目录太深的缘故)
(注2:大家也可先把D12TEST.sys文件先安装到c:\windows\system32\drivers目录下,而D12test.inf文件先安装到c:\windows\inf目录下)
(9)主机端安装usb成功之后,大家可在"我的电脑"-->"硬件"-->"设备管理器"-->"通用串行总线控制器"中看到增加了一项:
"Philips PDIUSBD12 Evaluation Board"
这表明usb驱动程序安装成功.
(10)然后运行LEDDEMO.EXE,通过单击这个程序大三个命令框,
可控制lumit4510上的led1,led2,led3灯的亮灭了!!
页:
[1]