kewei 发表于 2009-3-29 16:54:58

急急急急redhat 9下BCM5751M网卡问题!!

IBM本本R60E 装了redhat 9 ,内核自已编的2.4.37
网卡能驱动,但ping 不通网关,具体信息如何:
# ifconfig etho
eth0      Link encap:EthernetHWaddr 00:16:D3:28:14:F8
          inet addr:10.2.16.23Bcast:10.2.16.255Mask:255.255.255.0
          UP BROADCAST MULTICASTMTU:1500Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)TX bytes:0 (0.0 b)
          Interrupt:11
# ethtool eth0
Settings for eth0:
      Supported ports: [ MII ]
      Supported link modes:   10baseT/Half 10baseT/Full
                              100baseT/Half 100baseT/Full
                              1000baseT/Half 1000baseT/Full
      Supports auto-negotiation: Yes
      Advertised link modes:10baseT/Half 10baseT/Full
                              100baseT/Half 100baseT/Full
                              1000baseT/Half 1000baseT/Full
      Advertised auto-negotiation: Yes
      Speed: Unknown! (65535)
      Duplex: Unknown! (255)
      Port: Twisted Pair
      PHYAD: 1
      Transceiver: internal
      Auto-negotiation: on
      Supports Wake-on: g
      Wake-on: d
      Current message level: 0x000000ff (255)
      Link detected: no
#ethtool -s eth0 speed 100 duplex half autoneg off
# ethtool eth0
Settings for etho:
No data available
Settings for eth0:
        Supported ports: [ MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:Not reported
        Advertised auto-negotiation: No
        Speed: 100Mb/s
        Duplex: Half
        Port: Twisted Pair
        PHYAD: 1
        Transceiver: internal
        Auto-negotiation: off
        Supports Wake-on: g
        Wake-on: d
        Current message level: 0x000000ff (255)
        Link detected: no

# cat /proc/pci -v
PCI devices found:
Bus0, device   0, function0:
    Host bridge: PCI device 8086:27a0 (Intel Corp.) (rev 3).
Bus0, device   2, function0:
    VGA compatible controller: PCI device 8086:27a2 (Intel Corp.) (rev 3).
      IRQ 11.
      Non-prefetchable 32 bit memory at 0xee100000 .
      I/O at 0x1800 .
      Prefetchable 32 bit memory at 0xd0000000 .
      Non-prefetchable 32 bit memory at 0xee200000 .
Bus0, device   2, function1:
    Display controller: PCI device 8086:27a6 (Intel Corp.) (rev 3).
      Non-prefetchable 32 bit memory at 0xee180000 .
Bus0, device27, function0:
    Class 0403: PCI device 8086:27d8 (Intel Corp.) (rev 2).
      IRQ 11.
      Non-prefetchable 64 bit memory at 0xee240000 .
Bus0, device28, function0:
    PCI bridge: PCI device 8086:27d0 (Intel Corp.) (rev 2).
      Master Capable.No bursts.Min Gnt=4.
Bus0, device28, function1:
    PCI bridge: PCI device 8086:27d2 (Intel Corp.) (rev 2).
      Master Capable.No bursts.Min Gnt=4.
Bus0, device28, function2:
    PCI bridge: PCI device 8086:27d4 (Intel Corp.) (rev 2).
      Master Capable.No bursts.Min Gnt=4.
Bus0, device28, function3:
    PCI bridge: PCI device 8086:27d6 (Intel Corp.) (rev 2).
      Master Capable.No bursts.Min Gnt=4.
Bus0, device29, function0:
    USB Controller: PCI device 8086:27c8 (Intel Corp.) (rev 2).
      IRQ 11.
      I/O at 0x1820 .
Bus0, device29, function1:
    USB Controller: PCI device 8086:27c9 (Intel Corp.) (rev 2).
      IRQ 11.
      I/O at 0x1840 .
Bus0, device29, function2:
    USB Controller: PCI device 8086:27ca (Intel Corp.) (rev 2).
      IRQ 11.
      I/O at 0x1860 .
Bus0, device29, function3:
    USB Controller: PCI device 8086:27cb (Intel Corp.) (rev 2).
      IRQ 11.
      I/O at 0x1880 .
Bus0, device29, function7:
    USB Controller: PCI device 8086:27cc (Intel Corp.) (rev 2).
      IRQ 11.
      Non-prefetchable 32 bit memory at 0xee444000 .
Bus0, device30, function0:
    PCI bridge: Intel Corp. 82801BAM/CAM PCI Bridge (rev 226).
Bus0, device31, function0:
    ISA bridge: PCI device 8086:27b9 (Intel Corp.) (rev 2).
Bus0, device31, function2:
    IDE interface: PCI device 8086:27c4 (Intel Corp.) (rev 2).
      I/O at 0x18b0 .
Bus0, device31, function3:
    SMBus: PCI device 8086:27da (Intel Corp.) (rev 2).
      IRQ 11.
      I/O at 0x18e0 .
Bus2, device   0, function0:
    Ethernet controller: Broadcom Corporation NetXtreme BCM5751M Gigabit Ethernet (rev 33).
      IRQ 11.
      Non-prefetchable 64 bit memory at 0xee000000 .
Bus 21, device   0, function0:
    CardBus bridge: Texas Instruments PCI1510 PC card Cardbus Controller (rev 0).
      IRQ 11.
      Master Capable.Latency=168.Min Gnt=192.Max Lat=3.
      Non-prefetchable 32 bit memory at 0xe4300000 .

# cat /proc/ioports
0000-001f : dma1
0020-003f : pic1
0040-0043 : timer0
0050-0053 : timer1
0060-006f : keyboard
0070-007f : rtc
0080-008f : dma page reg
00a0-00bf : pic2
00c0-00df : dma2
00f0-00ff : fpu
0170-0177 : ide1
01f0-01f7 : ide0
0376-0376 : ide1
03c0-03df : vesafb
03f6-03f6 : ide0
0cf8-0cff : PCI conf1
1800-1807 : PCI device 8086:27a2 (Intel Corp.)
1820-183f : PCI device 8086:27c8 (Intel Corp.)
1840-185f : PCI device 8086:27c9 (Intel Corp.)
1860-187f : PCI device 8086:27ca (Intel Corp.)
1880-189f : PCI device 8086:27cb (Intel Corp.)
18b0-18bf : PCI device 8086:27c4 (Intel Corp.)
18e0-18ff : PCI device 8086:27da (Intel Corp.)
2000-3fff : PCI Bus #03
4000-5fff : PCI Bus #04
6000-7fff : PCI Bus #0c

kewei 发表于 2009-3-29 16:55:18

请高手帮忙分析一下哈,小弟不胜感激!!!!!!!!

[ 本帖最后由 kewei 于 2009-3-29 16:56 编辑 ]

jiangtao9999 发表于 2009-3-29 18:15:32

装 RH9 就不要问问题哈……
那版本太老了。

jozhu 发表于 2009-4-4 12:41:25

最简单的解决办法就是换个这两年出得发行版.RH9出了有小十年了...
页: [1]
查看完整版本: 急急急急redhat 9下BCM5751M网卡问题!!