请教下面题示是什么意思?
GRUB version 0.93 (639k lower/130048k upper memory)grub> 按TAB会列出可能的设备和文件名
也就是文件名自动补全 我怎样进入Xwindow了. ???????????????????????????????????谢谢! 我按了TAB,可是没列出可能的设备和文件名.
提示如下:
possible commands are:background blocklist boot cat chainloader clear cmp color configfile debug
displayapm displaymem embed find foreground fstest geometry halt help hide impsprobe initrd install ioprobe kernel lock makeactive map mds crypt module modulenounzip pager partnew parttype password pause read reboot roor rootnoverify savedefault serial setkey setup splashimage terminal terminfo testload testvbe unhide uppermem vbeprobe. 我只能用引导盘进系统,不能从硬盘引导系统, grub>root (hd0,*)
grub>setup (hd0)
*是你的linux引导分区，不知道就用Tab看一下，在输入完","号以后 我是40g的硬盘,swap 256mb 剩下的都给了/ 根分区 you didn't say about your problem clearly.so many people don't know what is what u need. 把/boot/grub/grub.conf贴出来 你怎么把grub跟Xwindow扯在一起，大家都看不明白你的意思。
startx进入X 我把/boot/grub/grub.conf贴出来,大家看看那不对,谢谢!
grub.conf generated by anaconda
#
# Note that you do not have to rerun grub after making changes to this file
# NOTICE:You do not have a /boot partition.This means that
# all kernel and initrd paths are relative to /, eg.
# root (hd0,0)
# kernel /boot/vmlinuz-version ro root=/dev/hdb1
# initrd /boot/initrd-version.img
#boot=/dev/hdb
default=0
timeout=10
splashimage=(hd0,0)/boot/grub/splash.xpm.gz
title Red Hat Linux (2.4.20-8)
root (hd0,0)
kernel /boot/vmlinuz-2.4.20-8 ro root=LABEL=/ hda=ide-scsi
initrd /boot/initrd-2.4.20-8.img 你装了windows了吗？如果装了就在grub.conf最后加入
title Windows
rootnoverify (hd0,0)
chainloader +1
然后
执行grub-install /dev/hda
如果没装执行执行上面命令 我按张恨水说的做了,提示我的bios超出最大支持分区
partition num:0,filesystem type is partition type. 0x83
partition num:1,
Error 18: selected cylinder exceeds maximum supported by bios 我没装windows,是不是只要
执行grub-install /dev/hda
页:
[1]
2