装上rh9.0不久，速度特慢，请教各位大虾有何优化之法？
我的机器配置：赛扬900,128sdram,815集成主板，20G硬盘,装上RH9.0之后，一切正常，但反应速度很慢，与Windows2k相比速度简直天壤之别。问各位大侠有何优化之法，可以使系统跑得快起来？ :?: 在配置桌面得时候，把特效降到最低，再加一条128m得内存，很便宜得哦，还有得优化方法，到精华里面找 1.去掉不必要的服务
剩下以下几个:
crond
syslogs
network
(用GNOME的服务配置调整)
2.修改/etc/sysconfig/harddisks
# These options are used to tune the hard drives -
# read the hdparm man page for more information
# Set this to 1 to enable DMA. This might cause some
# data corruption on certain chipset / hard drive
# combinations. This is used with the "-d" option
USE_DMA=1
# Multiple sector I/O. a feature of most modern IDE hard drives,
# permitting the transfer of multiple sectors per I/O interrupt,
# rather than the usual one sector per interrupt.When this feature
# is enabled, it typically reduces operating system overhead for disk
# I/O by 30-50%.On many systems, it also provides increased data
# throughput of anywhere from 5% to 50%.Some drives, however (most
# notably the WD Caviar series), seem to run slower with multiple mode
# enabled. Under rare circumstances, such failures can result in
# massive filesystem corruption. USE WITH CAUTION AND BACKUP.
# This is the sector count for multiple sector I/O - the "-m" option
#
MULTIPLE_IO=16
# (E)IDE 32-bit I/O support (to interface card)
#
EIDE_32BIT=3
# Enable drive read-lookahead
#
# LOOKAHEAD=1
# Add extra parameters here if wanted
# On reasonably new hardware, you may want to try -X66, -X67 or -X68
# Other flags you might want to experiment with are -u1, -a and -m
# See the hdparm manpage (man hdparm) for details and more options.
#
EXTRA_PARAMS=-X68 xfs也不要了，呵呵 ：） 字符狂人 内存太小 加内存
我的CPU是赛阳366，够古董吧？
但是我有256M内存，所以一点不觉的慢（不用Redhat） haha
我的也是古董,
我是CPU是赛样366,
内存才96
哈哈
是不是古董呀!!
哈哈哈 请问楼上的firefoxmmx,我家里的机器和你的差不多,装rh9+gome的话速度可以忍受吗?你装
的啥版本?不行就装rh7.2了. debian吧，redhat的软件很多莫名其妙，不要用gnonme和kde，用别的桌面，硬件要求就低了
页:
[1]