高手看看吧求救！我的猫咋弄呀！我用scanmodem后的显示
System information ------------------------redhat Red Hat Linux release 9 (Shrike)
on System with processor: i686
supported by kernel: 2.4.20-8
assembled with compiler:3.2.2
no gcc compiler installed
A /dev/modem symbolic link is not set.
COMM services are not active
PPP support modulebsd_comp.onot found!
Resident PPP support modules are properly uncompressed .
redhat is not yet providing pre-compiled drivers for WinModems
An AC97 modem codec was not detected
---------- End SIL_id section ---------------
Path to lspci is: /sbin/lspci
--------- lspci scan ----------------
PCI_bus
00:00.0 Host bridge: Intel Corp. 82815 815 Chipset Host Bridge and Memory Controller Hub (rev 02)
00:01.0 PCI bridge: Intel Corp. 82815 815 Chipset AGP Bridge (rev 02)
00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB PCI Bridge (rev 02)
00:1f.0 ISA bridge: Intel Corp. 82801BA ISA Bridge (LPC) (rev 02)
00:1f.1 IDE interface: Intel Corp. 82801BA IDE U100 (rev 02)
00:1f.2 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #1) (rev 02)
00:1f.3 SMBus: Intel Corp. 82801BA/BAM SMBus (rev 02)
00:1f.4 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #2) (rev 02)
00:1f.5 Multimedia audio controller: Intel Corp. 82801BA/BAM AC'97 Audio (rev 02)
01:00.0 VGA compatible controller: nVidia Corporation NV5 (rev 15)
02:0c.0 Communication controller: Rockwell International HSF 56k Data/Fax/Voice/Spkp (w/Handset) Modem (rev 01)
-------------------------------------
Modem candidates are at PCI_buses:02:0c.0
Providing detail for device at PCI_bus 02:0c.0
with vendor-ID:device-ID
----:----
Class 0780: 127a:2015 Communication controller: Rockwell International HSF 56k Data/Fax/Voice/Spkp (w/Handset) Modem (rev 01)
SubSystem 127a:2015 Rockwell International HSF 56k Data/Fax/Voice/Spkp (w/Handset) Modem
Flags: bus master, medium devsel, latency 32, IRQ 9
Memory at d8000000 (32-bit, non-prefetchable)
I/O ports at c000
Internal_test: ./scanModem test 127a:2015 127a:2015 redhat 2.4.20-8 3
Checking Subsystem against prior reports to [email protected]
This combination of softmodem controller and Subsystem:
127a:2015
SubSystem 127a:2015
has not been previously reported and YOU must run some tests.
Read Modem/SoftModem.txt for instructions.
The Codec is not recognized.
Information on several modem chipset providers is provided below,
because ambiguities remain on the correct choice of supporting software.
=== Checking 127a through chipset providers and modem assemblers ====
Vendors 127a and 14f1 are Conexant, successor to Vendor=148d Rockwell technology.
With respect to software support there are two main types, hcflinmodem* and hsflinmodem* .
The HCF (Host Controller Free) which have a digital signal processsing (DSP) chipset,
while the HSF in the soft modem family without a dsp.
HSF support of version 5.03 is included with SuSE 9.0 for support of2.4.21 version kernels.
For support of 2.6.n kernels, new releaseses are provided at http://www.Linuxant.com/drivers/
Linuxant is providing free test packages for low speed CONNECTs.
There is a one time subscription fee for full high speed support.
A detailed software installation example is provided at:
http://linmodems.technion.ac.il/archive-fourth/msg00350.html
SuSE Conexant installation Re: Emergency!!!/Date:/ Wed, 11 Feb 2004 06:10:39 -0500
Modems with the following PCI_IDs also have Conexant HCF (Controller free) chipsets.
1024:1024 (Zenith Data Systems)
148D:1003 (DIGICOM Systems)
158B:0015 (Allied Data Technologies TornadoVFM56x-PRC)
141A:1035 (Apache Micro)
The following six may be either HCF of HSF modems. Test the HSF package first
(127a,14f1):(1025,1085, 2005)
Should a HCF driver installation fail to serve among there,
then uninstall and instead try the HSF driver resource.
Subsystem HSF Conexant soft modems serve under AC97 or MC97 controllers. These include:
14f1:(5422 2002) , plus many others with vendors assigned PCI IDs.
SubSystem 104d:814e under a 1039:7013 Silicon Integrated Systems modem controlled has a Conexant chip
After loading of HSF drivers, there will be displayed by command: /sbin/lsmod
Module SizeUsed by Tainted: P
hsfich 119116 0(autoclean)
hsfserial 26388 0(autoclean)
hsfengine 1126348 0(autoclean)
hsfosspec 35328 0(autoclean)
plus many others not modem related.
While drivers are pre-compiled for some Linux distributions,
the installation of the HCF/HSF packages DOES in general require kernel-source/ preparation,
as described in Modem/DriverCompiling.txt.
A post install suggestion for adjusting PCI latency is:
http://phep2.technion.ac.il/linmodems/archive/msg05210.html
======= PCI_ID checking completed ======
Update=2004_Sept_30
A PCMCIA CardBus is not detected on this System.
GCCversion=
The following information blocks just query some ppp support items.
====================================================
grep ppp /etc/modules.conf
-------------------------------------
-------------------------------------
Be sure to read the section about ppp related modules and aliases in Modem/General.txt
DEVPPP=crw------- 1 root root 108, 0 2003-01-30 /dev/ppp
A /dev/modem symbolic link is not present
No devfsd.conf file found, indicated absense of the devfsd daemon package
for device file system (devfs) symbolic link support.
DEVFSD=
---- dmesg queries -------
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
The Modem/DriverCompiling.txtis a MUST READ,
if you are not experienced in configuring kernel-source/
or get "unresolved symbols" upon driver insertion.
Most recent WinModem fixes are in:http://linmodems.technion.ac.il/FAQ.html
页:
[1]