adsl在FC3上不能激活,望高手指教.
经过我的折腾后FC3基本可以在我的电脑上运行.现在最大的问题是adsl在FC3上不能激活.望高手指教
以下是adsl-start的debug信息:
---------------------------------------------
* The following section contains information about your system
Wed Dec1 01:32:59 CST 2004
Output of uname -a
Linux localhost 2.6.9-1.678_FC3 #1 Mon Nov 15 18:28:07 EST 2004 i686 athlon i386 GNU/Linux
---------------------------------------------
* The following section contains information about your network
* interfaces.The one you chose for PPPoE should contain the words:
* 'UP' and 'RUNNING'.If it does not, you probably have an Ethernet
* driver problem.
Output of ifconfig -a
eth0 Link encap:EthernetHWaddr 00:0A:EB:4E:0F:E0
BROADCAST MULTICASTMTU:1500Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b)TX bytes:0 (0.0 b)
Interrupt:10 Base address:0xec00
lo Link encap:Local Loopback
inet addr:127.0.0.1Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNINGMTU:16436Metric:1
RX packets:68 errors:0 dropped:0 overruns:0 frame:0
TX packets:68 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:5704 (5.5 KiB)TX bytes:5704 (5.5 KiB)
sit0 Link encap:IPv6-in-IPv4
NOARPMTU:1480Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0
RX bytes:0 (0.0 b)TX bytes:0 (0.0 b)
---------------------------------------------
* The following section contains information about kernel modules
* If the module for your Ethernet card is 'tulip', you might
* want to look for an updated version at http://www.scyld.com
Output of lsmod
Module SizeUsed by
radeon 1205172
md5 40331
ipv6 2327058
ipt_REJECT 64651
ipt_state 18571
ip_conntrack 406931 ipt_state
iptable_filter 27531
ip_tables 161933 ipt_REJECT,ipt_state,iptable_filter
nls_cp936 1265291
vfat 147851
fat 454091 vfat
dm_mod 547410
button 64810
battery 85170
ac 48050
uhci_hcd 314490
snd_via82xx 272372
snd_ac97_codec 644011 snd_via82xx
snd_pcm_oss 476090
snd_mixer_oss 172162 snd_pcm_oss
snd_pcm 979932 snd_via82xx,snd_pcm_oss
snd_timer 297651 snd_pcm
snd_page_alloc 96732 snd_via82xx,snd_pcm gameport 48011 snd_via82xx
snd_mpu401_uart 87691 snd_via82xx
snd_rawmidi 267251 snd_mpu401_uart
snd_seq_device 81371 snd_rawmidi
snd 5405311 snd_via82xx,snd_ac97_codec,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_timer,snd_mpu401_uart,snd_rawmidi,snd_seq_device
soundcore 98892 snd
8139too 263050
mii 46731 8139too
floppy 586090
reiserfs 2442451
---------------------------------------------
* The following section lists your routing table.
* If you have an entry which starts with '0.0.0.0', you probably
* have defined a default route and gateway, and pppd will
* not create a default route using your ISP.Try getting
* rid of this route.
Output of netstat -n -r
Kernel IP routing table
Destination Gateway Genmask Flags MSS Windowirtt Iface
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 lo
---------------------------------------------
Contents of /etc/resolv.conf
* The following section lists DNS setup.
* If you can browse by IP address, but not name, suspect
* a DNS problem.
--------------------------------------------- 我的网卡是8139too.
---------------------------------------------------
经过我的实经,用XFree4.4代替xorg, 好象能提高FC3的X的稳定性.
页:
[1]