打印

不能打开网页怎么回事

不能打开网页怎么回事

连接上了。但用浏览器打不开网页。我是adsl      4M网通。


root@slax:~# adsl-status
adsl-status: Link is up and running on interface ppp0
ppp0      Link encapoint-to-Point Protocol
          inet addr:221.206.163.98  P-t-P:10.100.100.1  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1492  Metric:1
          RX packets:16 errors:0 dropped:0 overruns:0 frame:0
          TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3
          RX bytes:684 (684.0 b)  TX bytes:30 (30.0 b)


root@slax:~# ping 221.206.163.98
PING 221.206.163.98 (221.206.163.9 56(84) bytes of data.
64 bytes from 221.206.163.98: icmp_seq=1 ttl=64 time=0.085 ms
64 bytes from 221.206.163.98: icmp_seq=2 ttl=64 time=0.072 ms
64 bytes from 221.206.163.98: icmp_seq=3 ttl=64 time=0.073 ms
64 bytes from 221.206.163.98: icmp_seq=4 ttl=64 time=0.073 ms
64 bytes from 221.206.163.98: icmp_seq=5 ttl=64 time=0.073 ms

--- 221.206.163.98 ping statistics ---
5 packets transmitted, 5 received, 0% packet loss, time 3998ms
rtt min/avg/max/mdev = 0.072/0.075/0.085/0.007 ms
root@slax:~#

TOP

还有怎么修改/etc/rc.d/rc.6 的内容。
我想退出时不弹出光驱

TOP

帮帮忙阿


Opera 8.01
网络故障

您试图访问的地址 http://www.baidu.com/ 目前不可用。请确保网址(URL)拼写和标点符号使用都正确,然后试着重新装入页面。
请确定您的 Internet 连接处于活动状态,然后再检查一下同一连接上的其它应用程序是否工作正常。
检查 Internet 安全防护软件的设置是否正确,是否阻碍了普通的 Web 浏览。
如果您在局域网的防火墙之后,而您认为防火墙可能给您带来各种问题,请联系您的系统管理员。
除非您确定您需要使用代理服务器才能连接到 Internet,否则请按键盘上的 F12 键,然后禁用代理服务器。重新装入页面。


Welcome to the Roaring Penguin ADSL client setup.  First, I will run
some checks on your system to make sure the PPPoE client is installed
properly...

Looks good!  Now, please enter some information:

USER NAME

>>> Enter your PPPoE user name (default******): ******

INTERFACE

>>> Enter the Ethernet interface connected to the ADSL modem
For Solaris, this is likely to be something like /dev/hme0.
For Linux, it will be ethn, where 'n' is a number.
(default eth0):

Do you want the link to come up on demand, or stay up continuously?
If you want it to come up on demand, enter the idle time in seconds
after which the link should be dropped.  If you want the link to
stay up permanently, enter 'no' (two letters, lower-case.)
NOTE: Demand-activated links do not interact well with dynamic IP
addresses.  You may have some problems with demand-activated links.
>>> Enter the demand value (default no):

DNS

Please enter the IP address of your ISP's primary DNS server.
If your ISP claims that 'the server will provide DNS addresses',
enter 'server' (all lower-case) here.
If you just press enter, I will assume you know what you are
doing and not modify your DNS setup.
>>> Enter the DNS information here: 202.97.227.138
Please enter the IP address of your ISP's secondary DNS server.
If you just press enter, I will assume there is only one DNS server.
>>> Enter the secondary DNS server address here: 202.98.96.68

PASSWORD

>>> Please enter your PPPoE password:
>>> Please re-enter your PPPoE password:

FIREWALLING

Please choose the firewall rules to use.  Note that these rules are
very basic.  You are strongly encouraged to use a more sophisticated
firewall setup; however, these will provide basic security.  If you
are running any servers on your machine, you must choose 'NONE' and
set up firewalling yourself.  Otherwise, the firewall rules will deny
access to all standard servers like Web, e-mail, ftp, etc.  If you
are using SSH, the rules will block outgoing SSH connections which
allocate a privileged source port.

The firewall choices are:
0 - NONE: This script will not set any firewall rules.  You are responsible
          for ensuring the security of your machine.  You are STRONGLY
          recommended to use some kind of firewall rules.
1 - STANDALONE: Appropriate for a basic stand-alone web-surfing workstation
2 - MASQUERADE: Appropriate for a machine acting as an Internet gateway
                for a LAN
>>> Choose a type of firewall (0-2): 0

** Summary of what you entered **

Ethernet Interface: eth0
User name:          ******
Activate-on-demand: No
Primary DNS:        202.97.227.138
Secondary DNS:      202.98.96.68
Firewalling:        NONE

>>> Accept these settings and adjust configuration files (y/n)? y
Adjusting /etc/ppp/pppoe.conf
Adjusting /etc/resolv.conf
  (But first backing it up to /etc/resolv.conf-bak)
Adjusting /etc/ppp/pap-secrets and /etc/ppp/chap-secrets
  (But first backing it up to /etc/ppp/pap-secrets-bak)
  (But first backing it up to /etc/ppp/chap-secrets-bak)



Congratulations, it should be all set up!

Type 'adsl-start' to bring up your ADSL link and 'adsl-stop' to bring
it down.  Type 'adsl-status' to see the link status.
root@slax:~# adsl-start
. Connected!
root@slax:~# adsl-status
adsl-status: Link is up and running on interface ppp0
ppp0      Link encapoint-to-Point Protocol
          inet addr:221.206.169.108  P-t-P:10.100.100.1  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1492  Metric:1
          RX packets:3 errors:0 dropped:0 overruns:0 frame:0
          TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3
          RX bytes:30 (30.0 b)  TX bytes:30 (30.0 b)

root@slax:~# ping 221.206.169.108
PING 221.206.169.108 (221.206.169.10 56(84) bytes of data.
64 bytes from 221.206.169.108: icmp_seq=1 ttl=64 time=0.090 ms
64 bytes from 221.206.169.108: icmp_seq=2 ttl=64 time=0.076 ms

--- 221.206.169.108 ping statistics ---
2 packets transmitted, 2 received, 0% packet loss, time 1000ms
rtt min/avg/max/mdev = 0.076/0.083/0.090/0.007 ms
root@slax:~# ping 202.97.227.138
PING 202.97.227.138 (202.97.227.13 56(84) bytes of data.
From 192.168.1.1 icmp_seq=1 Destination Net Unreachable
From 192.168.1.1 icmp_seq=2 Destination Net Unreachable
From 192.168.1.1 icmp_seq=3 Destination Net Unreachable
From 192.168.1.1 icmp_seq=4 Destination Net Unreachable

--- 202.97.227.138 ping statistics ---
4 packets transmitted, 0 received, +4 errors, 100% packet loss, time 2999ms

root@slax:~#

TOP

你的DNS不可用

TOP

我也是遇到这个问题啊。在WINDOWSXP下可以拨号上网,DNS什么的都一样,但是去到FANX下,就是用adsl-setup这样设置,一样打不开网页!!没有人知道怎么解决吗?

TOP