怎么打开显卡的3D啊？

minmim

各位DX，我是linux新手，前不久看到SUSE出了10.0就搞下来安装了，安装后倒也没什么问题，就是玩自带的游戏总说3D没开或没配置好。但我查阅了Nvidia的官方资料，称只要安装好驱动就自动打开了3D加速。我的显卡驱动因该说已经安装好了，在硬件信息里也显示了完整的显卡型号（Nvidia Gefore MX100/200）,这个问题那位能帮我参谋一下啊？谢谢了！

附Nvidia的说明：
1. (open)SuSE Linux 10.0-IA32

It is recommended to use YOU (YaST Online Update) for (re)installation
of the nvidia driver. There are several reasons for this. First, it's
simple. Second, and this is the most important one, you won't need to
recompile the nvidia kernel module after a kernel update.

Inside YOU enable "Installable and Installed Patches" for "Show Patch
Category" and select "Download NVIDIA(r) Graphics Driver" from the
patches list (usually at the bottom of the list). Note, that you need
to mark it as "Update" (right mouse click) if you already installed it
before and the driver was uninstalled - for any reason. Proceed as
usual now. After YOU has finished restart your Xserver (i.e. logout
from your Xsession) and you're fine.

People who aren't afraid of recompiling the nvidia kernel module or
even reinstalling the nvidia driver each time the kernel has been
updated and want or need to use the latest and greatest nvidia driver
can use the following steps 1-3. The others should use the
instructions above using YOU and skip the steps below.

1) Kernel sources must be installed and configured. Usually this means
installing the 'kernel-source', 'make' and 'gcc' packages with YaST2.
Update it - if not already done - via YaST2 Online Update (YOU).

2) Use the nvidia installer for 1.0-7676.

sh NVIDIA-Linux-x86-1.0-7676-pkg1.run -q

3) Configure X.Org with

sax2 -m 0=nvidia (0 is a digit, not a letter!)

NOTE: There is no need to try to enable 3D support. It's already
      enabled, when the nvidia driver is running.

月下刀客

要另外下载安装，在屏幕上方的自由软件区有。
安装方法参考一下本版3n的置顶帖

jozhu

比较简单的方法就是用YAST2升级系统，会自动为你安上驱动的，然后用YAST2来配置，SUSE果然把人养懒了

minmim

能详细说说怎么用YAST2来配置阿？我配置不出来啊~~~恳请赐教！！！

jozhu

YAST2 里的硬件设置里有打开3D这一项的啊，很简单的图形配置啊，看了就明白的，不过前提是你装了驱动

minmim

我的驱动应该是装好了吧，因为已经完整显示我的显卡型号了。斑竹说的那个配置我也看到，并且配置并保存了，但系统是让我保存到一个文件，我退出重启动后老样子啊，一点都没变过，3d还是没有。