ap:连接到指定的AP或者无线网络,后面的参数可以是AP的MAC地址,也可以是iwlist scan出来的标识符。如果是Ad-hoc,则连接到
一个已经存在的Ad-hoc网络。使用off参数让无线网卡不改变当前已连接的AP下进入自动模式。any/auto参数,无线网卡自动选择
最好的AP。
注意:如果无线信号低到一定程度,无线网络会进入自动选择AP模式。
示例:
#iwconfig eth0 ap 00:60:1D:01:23:45
#iwconfig eth0 ap any
#iwconfig eth0 ap off
rate/bit:如果无线网卡支持多速率,则可以通过该命令设置工作的速率。小于1000的参数由具体的无线网卡驱动定义,一般是传输速
率的索引值,大于1000的为速率,单位bps,可以在数字后面附带k, M, G来指定数量级。auto参数让无线网卡自动选择速率
fixed参数让无线网卡不使用自动速率模式。
示例:
#iwconfig eth0 rate 11M
#iwconfig eth0 rate auto
#iwconfig eth0 rate 5.5M auto //自动选择5.5M以下的速率
txpower:如果无线网卡支持多发射功率设定,则使用该参数设定发射,单位为dBm,如果指定为W(毫瓦),只转换公式为:
dBm=30+log(W)。参数on/off可以打开和关闭发射单元,auto和fixed指定无线是否自动选择发射功率。
示例:
#iwconfig eth0 txpower 15
#iwconfig eth0 txpower 30mW
#iwconfig eth0 txpower auto
#iwconfig eth0 txpower off
示例:
#iwconfig eth0 power period 2
#iwconfig eth0 power 500m unicast
#iwconfig eth0 power timeout 300u all
#iwconfig eth0 power off
#iwconfig eth0 power min period 2 power max period 4