Hi, I'm sorry, I want to use skyeye to simulate powerpc, but I get some error.
skyeye version is 1.3.5
mpc8560, mpc8572, mpc8641d, these three testcases in "skyeye-testsuite-1.3.4_rc1/linux" can't pass.
I use the default skyeye.conf in each testcases, only change "uart:mod=stdio" to "uart:mod=term".
The following is the output when I run mpc8560 testcase.
Could you tell me how to fix it?
gaojin@gaojin-OptiPlex-7020:~/skyeye-1.3.5_rc1/testsuite/mpc8560$ ../../skyeye -e vmlinux
SkyEye is an Open Source project under GPL. All rights of different parts or modules are reserved by their author. Any modification or redistributions of SkyEye should not remove or modify the annoucement of SkyEye copyright.
Get more information about it, please visit the homepage http://www.skyeye.org.
Type "help" to get command list.