在MAGIC2.0-rc1下安装VMware
安装VMware-workstation-5.0.0-13124.tar.gz安装好后运行 vmware 要我
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
我又运行config
make: Leaving directory `/tmp/vmware-config0/vmnet-only'
The module loads perfectly in the running kernel.
Starting VMware services:
Virtual machine monitor
Virtual ethernet
Bridged networking on /dev/vmnet0
Host-only networking on /dev/vmnet1 (background)
Host-only networking on /dev/vmnet2 (background)
NAT service on /dev/vmnet2
Host-only networking on /dev/vmnet3 (background)
NAT service on /dev/vmnet3
Host-only networking on /dev/vmnet4 (background)
NAT service on /dev/vmnet4
Host-only networking on /dev/vmnet5 (background)
NAT service on /dev/vmnet5
Host-only networking on /dev/vmnet6 (background)
NAT service on /dev/vmnet6
Host-only networking on /dev/vmnet8 (background)
NAT service on /dev/vmnet8
The configuration of VMware Workstation 5.0.0 build-13124 for Linux for this
running kernel completed successfully.
You can now run VMware Workstation by invoking the following command:
"/usr/bin/vmware".
Enjoy,
--the VMware team
最后
# vmware
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
还是一样 什么原因?我系统src没有源代码
谁帮帮我,该怎么弄
谢谢 就是叫你配置啊，安装完了当然要配置了啊 已经配置过一次 了还是老样子 具体 是哪出问题呢？？？
页:
[1]