在MAGIC2.0-rc1下安装VMware

beginzero

安装VMware-workstation-5.0.0-13124.tar.gz
安装好后运行 vmware 要我
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
我又运行config
make: Leaving directory `/tmp/vmware-config0/vmnet-only'
The module loads perfectly in the running kernel.

Starting VMware services:
   Virtual machine monitor                                 [  OK  ]
   Virtual ethernet                                        [  OK  ]
   Bridged networking on /dev/vmnet0                       [FAILED]
   Host-only networking on /dev/vmnet1 (background)        [  OK  ]
   Host-only networking on /dev/vmnet2 (background)        [  OK  ]
   NAT service on /dev/vmnet2                              [  OK  ]
   Host-only networking on /dev/vmnet3 (background)        [  OK  ]
   NAT service on /dev/vmnet3                              [  OK  ]
   Host-only networking on /dev/vmnet4 (background)        [  OK  ]
   NAT service on /dev/vmnet4                              [  OK  ]
   Host-only networking on /dev/vmnet5 (background)        [  OK  ]
   NAT service on /dev/vmnet5                              [  OK  ]
   Host-only networking on /dev/vmnet6 (background)        [  OK  ]
   NAT service on /dev/vmnet6                              [  OK  ]
   Host-only networking on /dev/vmnet8 (background)        [  OK  ]
   NAT service on /dev/vmnet8                              [  OK  ]

The configuration of VMware Workstation 5.0.0 build-13124 for Linux for this
running kernel completed successfully.

You can now run VMware Workstation by invoking the following command:
"/usr/bin/vmware".

Enjoy,


--the VMware team
最后
[root@MagicLinux bin]# vmware
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
还是一样 什么原因?我系统src没有源代码
谁帮帮我,该怎么弄
谢谢

zhz44

就是叫你配置啊，安装完了当然要配置了啊

beginzero

已经配置过一次 了还是老样子 具体 是哪出问题呢？？？