请问如果编译了内核之后，系统的速度最大有多少提升？
我的RH9始终感觉比WIN慢很多不知道通过编译内核之后能不能解决这个问题？ it depends on what kind of machine u use? what is u current configuration, and what is u definition on "slow".
no fixed answer. 我的意思是一般来说最大会有多少提升？ it still depends on what u want to do. may be 0, may be 100% or higher or -10%.
a low latency patch can improve u desktop responsiveness, but low u web server throughput. so u answer a too big question.
for u rh9, how many mem u have? how many service u start? use the meminfo, top, ... so many commands to find u bottleneck. 我感觉不到:mrgreen: i can feel, by using benchmark to measure.
performance optimization steps
1) find goals
2) find bottleneck
3) find solution
4) measure improvement
5) go to 1) 谢谢
必须要实际操作一下才行了哦
我的机器配置不高
M-P3 800
128M-4M共享显存
20G 4400转硬盘
可能是硬盘速度太慢了
用HDPARM优化了也只能到20M每秒 我只能感觉到启动速度稍快了一点。 u 4400rpm? i think it is 4500rpm. or 5400rpm. for this kind of ide disk, 20mb/s is normal. u mem is small, try to use icewm instead of kde. and recompile kernel with march=pentium3. Dragonfly, 斑竹您说是把需要的东西编译进内核好还是编译成模块好呢？
我以前是尽量编译成模块，现在是尽量编译进内核，但是却没发现系统快多少，比如网卡、ext3等 yes, once the module is loaded into kernel, there is no speed difference. so if a module u use it everyday, then compile into kernel, if no, then leave it as module. u 4400rpm? i think it is 4500rpm. or 5400rpm. for this kind of ide disk, 20mb/s is normal. u mem is small, try to use icewm instead of kde. and recompile kernel with march=pentium3.
有4400rpm,笔记本的 o, so i am wrong again.:-D:-D:-D
页:
[1]