菜鸟问:为什么serial ATA硬盘启动慢?和内核有关嘛?
小弟也不知道怎么装的,用redhat 9的2.4.20.8就装到serial ATA的硬盘上了,可是在读到下面代码的红色部分的之前特别慢,要一分钟:(请问大侠,是和内核有关嘛?另外,我升级过2.4.22,效果一样:(先谢谢了!NFORCE2: IDE controller at PCI slot 00:09.0
NFORCE2: chipset revision 162
NFORCE2: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA
SiI3112 Serial ATA: IDE controller at PCI slot 01:0c.0
SiI3112 Serial ATA: chipset revision 2
SiI3112 Serial ATA: not 100% native mode: will probe irqs later
ide2: MMIO-DMA at 0xf880d000-0xf880d007, BIOS settings: hde:pio, hdf:pio
ide3: MMIO-DMA at 0xf880d008-0xf880d00f, BIOS settings: hdg:pio, hdh:pio
hda: JLMS XJ-HD166S, ATAPI CD/DVD-ROM drive
hdb: LITE-ON LTR-52327S, ATAPI CD/DVD-ROM drive
hde: ST380013AS, ATA DISK drive
[color=red]hdg: no response (status = 0xfe)[/color]
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide2 at 0xf880d080-0xf880d087,0xf880d08a on irq 11
hde: host protected area => 1
hde: 156301488 sectors (80026 MB) w/8192KiB Cache, CHS=9729/255/63
ide-floppy driver 0.99.newide
Partition check:
hde: hde1 hde2 < hde5 hde6 hde7 > hde3 hde4
倒,红色部分就是
hdg: no response (status = 0xfe) what is u hdg? sata disk? thanks your reply,hehe~!
I have solved this problem from another foreign forum.
hdg is condidered to be the secondary slot for SATA. Because mine is solo,I just add "hdg=none" in the grub config file. 看来你启动的时候需要加 IDE 参数.
ide0=0x1f0,0x3f6,14 ide1=0x170,0x376,15 ide2=0 ide3=0......ide9=0
非标准 IDE 接口可能要在这些旧有系统中需要提供驱动.
去芯片主页找找. 不知道各个发行版的新版 Linux 会不会加入这些设备的支持
页:
[1]