skyeye_insight在redhat as4上编译出错

liboyang_bj

redhat as4
./configure --target=arm-elf --prefix=/usr/local
无异常
make报错如下：

if [ -f $libtooldir/libopcodes.a ]; then \
  cp $libtooldir/libopcodes.a libopcodes.tmp; \
  ranlib libopcodes.tmp; \
  /bin/sh ./../move-if-change libopcodes.tmp libopcodes.a; \
else true; fi
touch stamp-lib
make[3]: Leaving directory `/home/lby/src/skyeye_insight/opcodes'
make[2]: Leaving directory `/home/lby/src/skyeye_insight/opcodes'
make[1]: Leaving directory `/home/lby/src/skyeye_insight/opcodes'
make[1]: Entering directory `/home/lby/src/skyeye_insight/tcl'
make[2]: Entering directory `/home/lby/src/skyeye_insight/tcl/unix'
autoconf ./../unix/configure.in > ./../unix/configure
../unix/configure.in:187: error: do not use LIBOBJS directly, use AC_LIBOBJ (see section `AC_LIBOBJ vs LIBOBJS'
      If this token and others are legitimate, please use m4_pattern_allow.
      See the Autoconf documentation.
make[2]: *** [../unix/configure] Error 1
make[2]: Leaving directory `/home/lby/src/skyeye_insight/tcl/unix'
make[1]: *** [all] Error 2
make[1]: Leaving directory `/home/lby/src/skyeye_insight/tcl'
make: *** [all-tcl] Error 2

请问为啥？
谢谢！

liboyang_bj

问题解决了，查了资料：

然后将../tcl/unix/configure.in的187行：
#LIBOBJS="$LIBOBJS strstr.o"
更改为
AC_LIBOBJ([strstr])

通过了。

liboyang_bj

相关说明如下：
http://www.gnu.org/software/autoconf/manual/autoconf-2.57/html_node/autoconf_165.html