我按照getghost兄的建议执行sax2
它提示我要runlever 3才行
我就init 3
然后SaX2
它显示如下:
-the card is still not supported. To get further information about the driver status plesase have a look at:http://http://www.x.org
-the card was not detected correctly.In this case plesase get the information which X11 module provide support for the card and set the module using the following command:
sax2 -m 0=<name of the module>
Note:0 is a dihit not a letter
Note:Information about modules are provided on the mentioned www-Page
-the card was detected but the server fails to start in spite of the detection.In this case something more serious had happend.Please have a look at the log file:
/var/log/SaX.log
XC:if you can not determine the cause please get in contact with:<[email protected]>
Please include the log file and a detailed description into your e-mail
XCL:abort:...
请大虾继续指点,谢谢