skyeye-1.2-RC8-3不支持xscale吗？？

ssancel

下载了skyeye-1.2-RC8-3.tar.bz2
解压后，用make在binary文件夹下生成了一个skyeye.
可是好像这个不能用，没有支持xscale？？
不知道是不是没有安装好。

[lin@localhost u-boot-1.1.6]$ ../skyeye-v1/binary/skyeye
SKYEYE: If you have ELF kernel file, please use -e option to indicate your ELF format kernel filename
SKYEYE: If you only have kernel binary image, you should put the filename of kernel binary image in skyeye.conf file
arch: arm
Error: Unkonw cpu name "xscale"
Error: Unkonw cpu name "xscale"
"cpu" option parameter error!
mach info: name pxa_lubbock, mach_init addr 0x806c454
Segmentation fault
而我用skyeye-v0.7.4.rh9.bin却可以运行。
skyeye.conf文件如下：
cpu: xscale
mach: pxa_lubbock
mem_bank: map=I, type=RW, addr=0x40000000, size=0x0c000000
mem_bank: map=M, type=RW, addr=0xa0000000, size=0x00200000, file=./u-boot, boot=yes
mem_bank: map=M, type=RW, addr=0xa0200000, size=0x00200000
mem_bank: map=M, type=RW, addr=0xa0400000, size=0x00c00000
mem_bank: map=M, type=RW, addr=0xa1000000, size=0x00800000
mem_bank: map=M, type=RW, addr=0xa1800000, size=0x02800000
mem_bank: map=M, type=R,  addr=0x00000000, size=0x000c0000
mem_bank: map=M, type=R,  addr=0x000c0000, size=0x00200000

ksh

Skyeye is changed a lot after 1.0 version. Please read README file under skyeye source package.