|
|
发表于 2008-8-8 10:37:14
|
显示全部楼层
无线网卡还是驱动不起来
根据se兄发的那个连接把rt73usb、rt2570、rt2x00lib三个模块都在/etc/modprobe.d/blacklist中禁用了，重新启动的时候报了一大堆关于usb驱动的错，但是无线网卡还是驱动不起来，到dmesg的时候仍然没有wlan0的设备，而且会有以下部分的报错：
Initializing USB Mass Storage driver...
usb 2-3: device descriptor read/64, error -110
usb 2-3: device descriptor read/64, error -110
usb 2-3: new high speed USB device using ehci_hcd and address 4
usb 2-3: device descriptor read/64, error -110
usb 2-3: device descriptor read/64, error -110
usb 2-3: new high speed USB device using ehci_hcd and address 5
usb 2-3: device descriptor read/8, error -110
usb 2-3: device descriptor read/8, error -110
usb 2-3: new high speed USB device using ehci_hcd and address 6
usb 2-3: device descriptor read/8, error -110
usb 2-3: device descriptor read/8, error -110
hub 2-0:1.0: unable to enumerate USB device on port 3
usb 5-1: new low speed USB device using uhci_hcd and address 2
usb 5-1: configuration #1 chosen from 1 choice
usb 5-1: New USB device found, idVendor=1267, idProduct=0201
usb 5-1: New USB device strings: Mfr=0, Product=1, SerialNumber=0
usb 5-1: Product: USB Mouse
usb 6-1: new full speed USB device using uhci_hcd and address 2
uhci_hcd 0000:00:1d.1: Unlink after no-IRQ? Controller is probably using the wrong IRQ.
usb 6-1: device descriptor read/64, error -110
usb 6-1: device descriptor read/64, error -110
usb 6-1: new full speed USB device using uhci_hcd and address 3
usb 6-1: device descriptor read/64, error -110
usb 6-1: device descriptor read/64, error -110
usb 6-1: new full speed USB device using uhci_hcd and address 4
usb 6-1: device descriptor read/8, error -110
usb 6-1: device descriptor read/8, error -110
usb 6-1: new full speed USB device using uhci_hcd and address 5
usb 6-1: device descriptor read/8, error -110
usb 6-1: device descriptor read/8, error -110
hub 6-0:1.0: unable to enumerate USB device on port 1
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver libusual
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
drivers/usb/serial/usb-serial.c: USB Serial Driver core
PNP: PS/2 Controller [PNP0303 S2K,PNP0f13S2M] at 0x60,0x64 irq 1,12
i8042.c: Detected active multiplexing controller, rev 1.1.
serio: i8042 KBD port at 0x60,0x64 irq 1
serio: i8042 AUX0 port at 0x60,0x64 irq 12
serio: i8042 AUX1 port at 0x60,0x64 irq 12
serio: i8042 AUX2 port at 0x60,0x64 irq 12
serio: i8042 AUX3 port at 0x60,0x64 irq 12
mice: PS/2 mouse device common for all mice
input: AT Raw Set 2 keyboard as /class/input/input4
md: raid0 personality registered for level 0
md: raid1 personality registered for level 1
md: raid10 personality registered for level 10
raid6: int32x1 637 MB/s
raid6: int32x2 670 MB/s
raid6: int32x4 454 MB/s
raid6: int32x8 427 MB/s
raid6: mmxx1 2001 MB/s
raid6: mmxx2 2326 MB/s
raid6: sse1x1 1380 MB/s
raid6: sse1x2 1742 MB/s
raid6: sse2x1 2429 MB/s
raid6: sse2x2 2718 MB/s
raid6: using algorithm sse2x2 (2718 MB/s)
md: raid6 personality registered for level 6
md: raid5 personality registered for level 5
md: raid4 personality registered for level 4
md: multipath personality registered for level -4
device-mapper: ioctl: 4.13.0-ioctl (2007-10-1 initialised: [email protected]
EDAC MC: Ver: 2.1.0 Jul 8 2008
EISA: Probing bus 0 at eisa.0
Cannot allocate resource for EISA slot 1
Cannot allocate resource for EISA slot 2
Cannot allocate resource for EISA slot 3
Cannot allocate resource for EISA slot 4
EISA: Detected 0 cards.
cpuidle: using governor ladder
cpuidle: using governor menu
Marking TSC unstable due to: TSC halts in idle.
usbcore: registered new interface driver hiddev
input: USB Mouse as /class/input/input5
input: USB HID v1.00 Mouse [USB Mouse] on usb-0000:00:1d.0-1
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
NET: Registered protocol family 26
TCP cubic registered
Initializing XFRM netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
Starting balanced_irq
Using IPI No-Shortcut mode
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
Freeing unused kernel memory: 524k freed
input: PS/2 Logitech Wheel Mouse as /class/input/input6
ReiserFS: sda10: found reiserfs format "3.6" with standard journal
ReiserFS: sda10: using ordered data mode
ReiserFS: sda10: journal params: device sda10, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30
ReiserFS: sda10: checking transaction log (sda10)
ReiserFS: sda10: Using r5 hash to sort names
shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
ACPI Error (utobject-0502): Unsupported Reference opcode=88 in object f798e40c [20070126]
ACPI: device:06 is registered as cooling_device2
Monitor-Mwait will be used to enter C-3 state
iTCO_vendor_support: vendor-support=0
input: Video Bus as /class/input/input7
iTCO_wdt: Intel TCO WatchDog Timer Driver v1.02 (26-Jul-2007)
iTCO_wdt: Found a ICH8M TCO device (Version=2, TCOBASE=0x1060)
iTCO_wdt: initialized. heartbeat=30 sec (nowayout=0)
ACPI: PCI Interrupt 0000:00:1f.3[C] -> GSI 19 (level, low) -> IRQ 19
input: PC Speaker as /class/input/input8
ACPI: Video Device [GFX0] (multi-head: yes rom: no post: no)
r8169 Gigabit Ethernet driver 2.2LK loaded
ACPI: PCI Interrupt 0000:06:00.0[A] -> GSI 19 (level, low) -> IRQ 19
PCI: Setting latency timer of device 0000:06:00.0 to 64
r8169 0000:06:00.0: no MSI. Back to INTx.
eth0: RTL8101e at 0xf8dfc000, 00:03:0d:7b:2b:61, XID 34000000 IRQ 19
ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 22
PCI: Setting latency timer of device 0000:00:1b.0 to 64
rtc_cmos: probe of 00:07 failed with error -16
hda_codec: Unknown model for ALC883, trying auto-probe from BIOS...
Non-volatile memory driver v1.2
Clocksource tsc unstable (delta = -240909697 ns)
floppy0: no floppy controllers found
lp: driver loaded but no devices found
sonypi: Sony Programmable I/O Controller Driver v1.26.
ACPI: WMI: Mapper loaded
md: Autodetecting RAID arrays.
md: Scanned 0 and added 0 devices.
md: autorun ...
md: ... autorun DONE.
fuse init (API version 7.9)
FAT: Unrecognized mount option "locale=zh_CN.GB18030" or missing value
Adding 449780k swap on /dev/sda11. Priority:-1 extents:1 across:449780k
warning: process `kudzu' used the deprecated sysctl system call with 1.23.
r8169: eth0: link down
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
Installing knfsd (copyright (C) 1996 [email protected]).
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP ver 2.9
Bluetooth: L2CAP socket layer initialized
usb 6-1: new full speed USB device using uhci_hcd and address 6
usb 6-1: device descriptor read/64, error -110
usb 6-1: device descriptor read/64, error -110
usb 6-1: new full speed USB device using uhci_hcd and address 7
usb 6-1: device descriptor read/64, error -110
usb 6-1: device descriptor read/64, error -110
usb 6-1: new full speed USB device using uhci_hcd and address 8
usb 6-1: device descriptor read/8, error -110
usb 6-1: device descriptor read/8, error -110
usb 6-1: new full speed USB device using uhci_hcd and address 9
usb 6-1: device descriptor read/8, error -110
usb 6-1: device descriptor read/8, error -110
hub 6-0:1.0: unable to enumerate USB device on port 1
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
Bluetooth: HIDP (Human Interface Emulation) ver 1.2
warning: `avahi-daemon' uses 32-bit capabilities (legacy support in use)
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
ADDRCONF(NETDEV_UP): eth0: link is not ready
ACPI Error (utobject-0502): Unsupported Reference opcode=88 in object f798ee34 [20070126]
ACPI Error (utobject-0502): Unsupported Reference opcode=88 in object f78c4ed4 [20070126]
ACPI Error (utobject-0502): Unsupported Reference opcode=88 in object f78c4f4c [20070126]
[drm] Initialized drm 1.1.0 20060810
ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 16 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:00:02.0 to 64
[drm] Initialized i915 1.6.0 20060119 on minor 0
ACPI Error (utobject-0502): Unsupported Reference opcode=88 in object f798ee34 [20070126]
ACPI Error (utobject-0502): Unsupported Reference opcode=88 in object f78c4ed4 [20070126]
ACPI Error (utobject-0502): Unsupported Reference opcode=88 in object f78c4f4c [20070126]
usb 6-1: new full speed USB device using uhci_hcd and address 10
usb 6-1: device descriptor read/64, error -110
ndiswrapper version 1.53 loaded (smp=yes, preempt=no)
usb 6-1: device descriptor read/64, error -110
usb 6-1: new full speed USB device using uhci_hcd and address 11
usb 6-1: device descriptor read/64, error -110
usb 6-1: device descriptor read/64, error -110
hub 6-0:1.0: unable to enumerate USB device on port 1
usbcore: deregistering interface driver ndiswrapper
ndiswrapper version 1.53 loaded (smp=yes, preempt=no)
usbcore: registered new interface driver ndiswrapper |
|
IP卡
狗仔卡
显身卡