如何安装mplayer1.0pre4?

coocon

我下载了1.0pre4后在/usr/local 下解压缩后，在终端运行./configure 后出现很多警告，如：warning:'used' attribute ignored 请问怎么回事？我的软件包应该都装了。安装完成后怎么运行啊？我是菜鸟，请大家指点！

DaNmarner

安装好图形界面以后运行gmplayer，输出如下

---------------------------------------------------------------------------------
MPlayer 1.0pre4-3.2.2 (C) 2000-2004 MPlayer Team

CPU: Intel Celeron 2/Pentium III Coppermine,Geyserville 801.9 MHz (Family: 6, St
epping: 6)
Detected cache-line size is 32 bytes
CPUflags:  MMX: 1 MMX2: 1 3DNow: 0 3DNow2: 0 SSE: 1 SSE2: 0
Compiled for x86 CPU with extensions: MMX MMX2 SSE

Reading config file /usr/local/etc/mplayer/mplayer.conf: 没有那个文件或目录
Reading config file /home/dan/.mplayer/config
[cfg] read config file: /home/dan/.mplayer/gui.conf
Reading config file /home/dan/.mplayer/gui.conf: No such file or directory
vo: X11 running at 800x600 with depth 24 and 32 bpp (":0.0" => local display)
Reading /home/dan/.mplayer/codecs.conf: Can't open '/home/dan/.mplayer/codecs.co
nf': 没有那个文件或目录
Reading /usr/local/etc/mplayer/codecs.conf: Can't open '/usr/local/etc/mplayer/c                              odecs.conf': 没有那个文件或目录
Using built-in default codecs.conf.
font: can't open file: /home/dan/.mplayer/font/font.desc
font: can't open file: /usr/local/share/mplayer/font/font.desc
Linux RTC init error in ioctl (rtc_irqp_set 1024): 权限不够
Try adding "echo 1024 > /proc/sys/dev/rtc/max-user-freq" to your system startup                               scripts.
Using usleep() timing
Can't open input config file /home/dan/.mplayer/input.conf: 没有那个文件或目录
Can't open input config file /usr/local/etc/mplayer/input.conf: 没有那个文件或目                              录
Falling back on default (hardcoded) input config
Setting up LIRC support...
mplayer: could not connect to socket
mplayer: 没有那个文件或目录
Failed to open LIRC support.
You will not be able to use your remote control.
SKIN dir 1: '/home/dan/.mplayer/Skin'
SKIN dir 2: '/usr/local/share/mplayer/Skin'
[skin] file ( /usr/local/share/mplayer/Skin/default/skin ) not found.

---------------------------------------------------------------------------------

我下了一个skin解在~/.mplayer/Skin下面还是这样，请问该如何解决？

neptune

coocon,好像没有正确安装吧.

在/usr/local 下解压缩

,其实不用在/usr/local下解压的,随便一个目录,例如/home都可以
应该以超级用户的身分运行./configure; make; make install三个命令编译并安装.
-------------------------------

我下了一个skin解在~/.mplayer/Skin下面还是这样

如果你安装的不是mplayer默认的skin,要修改mplayer.conf 指定 skin = 皮肤名
这样mplayer 才能找到皮肤

wjping119

解压在哪儿都行，./configure --prefix=/usr试试吧

macarthor

./configure和make都可以用普通用户执行
make根据安装路径的权限而定是否用sudo

macarthor

http://www.linuxsir.org/bbs/showthread.php?s=&threadid=125985
这个里边说得很详细，按部就班就可以了

coocon

是不是用tar -zxvf 解压.tar.gz 文件啊?我用tar -zxvf 解压缩mplayer.tar.gz文件后
出现很多的不允许操作:
mplayer plug-in/source/stub.c:can't chang ownership to uid 500,gid 500:不允许操作
请问为什么啊?应该怎么安装?

macarthor

首先，确定对当前目录有没有写入权限

其次，不要在fat32分区解压缩，因为tar xzf 1.tar.gz不能写入fat32分区，至少常出现问题；在ext2/3分区解压缩