高手看看吧求救！我的猫咋弄呀！我用scanmodem后的显示

ttchihi123

System information ------------------------
redhat Red Hat Linux release 9 (Shrike)
on System with processor: i686
supported by kernel:      2.4.20-8
assembled with compiler:  3.2.2
no gcc compiler installed
A /dev/modem symbolic link is not set.
COMM services are not active
PPP support module  bsd_comp.o  not found!
Resident PPP support modules are properly uncompressed .
  redhat is not yet providing pre-compiled drivers for WinModems

An AC97 modem codec was not detected

---------- End SIL_id section ---------------

Path to lspci is: /sbin/lspci
--------- lspci scan ----------------
PCI_bus
00:00.0 Host bridge: Intel Corp. 82815 815 Chipset Host Bridge and Memory Controller Hub (rev 02)
00:01.0 PCI bridge: Intel Corp. 82815 815 Chipset AGP Bridge (rev 02)
00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB PCI Bridge (rev 02)
00:1f.0 ISA bridge: Intel Corp. 82801BA ISA Bridge (LPC) (rev 02)
00:1f.1 IDE interface: Intel Corp. 82801BA IDE U100 (rev 02)
00:1f.2 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #1) (rev 02)
00:1f.3 SMBus: Intel Corp. 82801BA/BAM SMBus (rev 02)
00:1f.4 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #2) (rev 02)
00:1f.5 Multimedia audio controller: Intel Corp. 82801BA/BAM AC'97 Audio (rev 02)
01:00.0 VGA compatible controller: nVidia Corporation NV5 [RIVA TNT2/TNT2 Pro] (rev 15)
02:0c.0 Communication controller: Rockwell International HSF 56k Data/Fax/Voice/Spkp (w/Handset) Modem (rev 01)
-------------------------------------

Modem candidates are at PCI_buses:  02:0c.0
Providing detail for device at PCI_bus 02:0c.0
  with vendor-ID:device-ID
            ----:----
Class 0780: 127a:2015   Communication controller: Rockwell International HSF 56k Data/Fax/Voice/Spkp (w/Handset) Modem (rev 01)
  SubSystem 127a:2015   Rockwell International HSF 56k Data/Fax/Voice/Spkp (w/Handset) Modem
        Flags: bus master, medium devsel, latency 32, IRQ 9
        Memory at d8000000 (32-bit, non-prefetchable) [size=64K]
        I/O ports at c000

Internal_test:   ./scanModem test 127a:2015 127a:2015 redhat 2.4.20-8 3

Checking Subsystem against prior reports to [email protected]
This combination of softmodem controller and Subsystem:
        127a:2015
        SubSystem 127a:2015
has not been previously reported and YOU must run some tests.

Read Modem/SoftModem.txt for instructions.

The Codec is not recognized.
      
Information on several modem chipset providers is provided below,
because ambiguities remain on the correct choice of supporting software.
            
=== Checking 127a through chipset providers and modem assemblers ====

Vendors 127a and 14f1 are Conexant, successor to Vendor=148d Rockwell technology.
With respect to software support there are two main types, hcflinmodem* and hsflinmodem* .
The HCF (Host Controller Free) which have a digital signal processsing (DSP) chipset,
while the HSF in the soft modem family without a dsp.
HSF support of version 5.03 is included with SuSE 9.0 for support of  2.4.21 version kernels.
For support of 2.6.n kernels, new releaseses are provided at http://www.Linuxant.com/drivers/
   Linuxant is providing free test packages for low speed CONNECTs.
   There is a one time subscription fee for full high speed support.
A detailed software installation example is provided at:
   http://linmodems.technion.ac.il/archive-fourth/msg00350.html
     SuSE Conexant installation Re: Emergency!!!  /Date:/ Wed, 11 Feb 2004 06:10:39 -0500
Modems with the following PCI_IDs also have Conexant HCF (Controller free) chipsets.
  1024:1024 (Zenith Data Systems)
  148D:1003 (DIGICOM Systems)
  158B:0015 (Allied Data Technologies Tornado  VFM56x-PRC)
  141A:1035 (Apache Micro)
The following six may be either HCF of HSF modems. Test the HSF package first
  (127a,14f1)1025,1085, 2005)
  Should a HCF driver installation fail to serve among there,
  then uninstall and instead try the HSF driver resource.
Subsystem HSF Conexant soft modems serve under AC97 or MC97 controllers. These include:
  14f15422 2002) , plus many others with vendors assigned PCI IDs.
  SubSystem 104d:814e under a 1039:7013 Silicon Integrated Systems modem controlled has a Conexant chip

After loading of HSF drivers, there will be displayed by command: /sbin/lsmod
Module                  Size  Used by    Tainted: P
hsfich                119116   0  (autoclean)
hsfserial              26388   0  (autoclean)
hsfengine            1126348   0  (autoclean) [hsfserial]
hsfosspec              35328   0  (autoclean) [hsfich hsfserial hsfengine]
     plus many others not modem related.
While drivers are pre-compiled for some Linux distributions,
   the installation of the HCF/HSF packages DOES in general require kernel-source/ preparation,
   as described in Modem/DriverCompiling.txt.
A post install suggestion for adjusting PCI latency is:
         http://phep2.technion.ac.il/linmodems/archive/msg05210.html


  ======= PCI_ID checking completed ======
Update=2004_Sept_30
A PCMCIA CardBus is not detected on this System.
GCCversion=
The following information blocks just query some ppp support items.
====================================================
   grep ppp /etc/modules.conf
-------------------------------------

-------------------------------------
Be sure to read the section about ppp related modules and aliases in Modem/General.txt
DEVPPP=crw------- 1 root root 108, 0 2003-01-30 /dev/ppp
A /dev/modem symbolic link is not present

No devfsd.conf file found, indicated absense of the devfsd daemon package
for device file system (devfs) symbolic link support.

DEVFSD=
---- dmesg queries -------
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)

The Modem/DriverCompiling.txt  is a MUST READ,
if you are not experienced in configuring kernel-source/
or get "unresolved symbols" upon driver insertion.

  Most recent WinModem fixes are in:  http://linmodems.technion.ac.il/FAQ.html