关于vmware for linux

beginzero

我装的是公社的magic 2 RC1
好象光盘没
kernel-header-source（或kernel-source）包
吧
那怎么配置vmware啊
是不是必须装???
那哪里有下的?

xx_zz

ML的kernel已经打包了必要的源码了，除非你要自己重新编译kernel，不然没有必要再专门安装kernel-source。现有的环境下安装vmware是没问题的。

beginzero

安装好后运行 vmware 要我
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
我又运行config
make: Leaving directory `/tmp/vmware-config0/vmnet-only'
The module loads perfectly in the running kernel.

Starting VMware services:
Virtual machine monitor [ OK ]
Virtual ethernet [ OK ]
Bridged networking on /dev/vmnet0 [FAILED]
Host-only networking on /dev/vmnet1 (background) [ OK ]
Host-only networking on /dev/vmnet2 (background) [ OK ]
NAT service on /dev/vmnet2 [ OK ]
Host-only networking on /dev/vmnet3 (background) [ OK ]
NAT service on /dev/vmnet3 [ OK ]
Host-only networking on /dev/vmnet4 (background) [ OK ]
NAT service on /dev/vmnet4 [ OK ]
Host-only networking on /dev/vmnet5 (background) [ OK ]
NAT service on /dev/vmnet5 [ OK ]
Host-only networking on /dev/vmnet6 (background) [ OK ]
NAT service on /dev/vmnet6 [ OK ]
Host-only networking on /dev/vmnet8 (background) [ OK ]
NAT service on /dev/vmnet8 [ OK ]

The configuration of VMware Workstation 5.0.0 build-13124 for Linux for this
running kernel completed successfully.

You can now run VMware Workstation by invoking the following command:
"/usr/bin/vmware".

Enjoy,


--the VMware team
最后
[root@MagicLinux bin]# vmware
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
已经配置过一次 了还是老样子 具体 是哪出问题呢？？？

xx_zz

看看是不是这个的问题：
http://www.linuxfans.org/nuke/modules.php?name=Site_Downloads&op=geninfo&did=3617
我在RC1上用18007版本不用补丁也没有问题。 :-)