|
|
楼主 |
发表于 2003-3-19 10:06:36
|
显示全部楼层
硬件说明
[root@get03c0043 etc]# dmesg
Linux version 2.4.18-14 ([email protected]) (gcc version
3.2 20020903 (Red Hat Linux 8.0 3.2-7)) #1 Wed Sep 4 13:35:50 EDT 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000000fff0000 (usable)
BIOS-e820: 000000000fff0000 - 000000000fff3000 (ACPI NVS)
BIOS-e820: 000000000fff3000 - 0000000010000000 (ACPI data)
BIOS-e820: 00000000ffb00000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
255MB LOWMEM available.
On node 0 totalpages: 65520
zone(0): 4096 pages.
zone(1): 61424 pages.
zone(2): 0 pages.
Kernel command line: ro root=/dev/hda6 hdc=ide-scsi
ide_setup: hdc=ide-scsi
Initializing CPU#0
Detected 1003.808 MHz processor.
Speakup v-1.00 CVS: Tue Jun 11 14:22:53 EDT 2002 : initialized
Console: colour VGA+ 80x25
Calibrating delay loop... 1997.32 BogoMIPS
Memory: 253000k/262080k available (1326k kernel code, 6648k reserved, 999k d
ata, 212k init, 0k highmem)
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount cache hash table entries: 4096 (order: 3, 32768 bytes)
ramfs: mounted with options: <defaults>
ramfs: max_pages=31880 max_file_pages=0 max_inodes=0 max_dentries=31880
Buffer cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0387f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
CPU: After vendor init, caps: 0387f9ff 00000000 00000000 00000000
CPU serial number disabled.
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 06
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch ([email protected])
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb370, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router PIIX [8086/2410] at 00:1f.0
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
speakup: initialized device: /dev/synth, node (MAJOR 10, MINOR 25)
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
Starting kswapd
VFS: Diskquotas version dquot_6.5.0 initialized
pty: 2048 Unix98 ptys configured
Serial driver version 5.05c (2001-07-0 with MANY_PORTS MULTIPORT SHARE_IRQ
SERIAL_PCI ISAPNP enabled
ttyS0 at 0x03f8 (irq = 4) is a 16550A
ttyS1 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
oprofile: mapping APIC.
oprofile: enabled local APIC. Err code 00000000
oprofile 0.2 loaded, major 254
block: 480 slots per queue, batch=120
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev f9
PIIX4: chipset revision 2
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio
hda: ST340016A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
blk: queue c03c0004, I/O limit 4095Mb (mask 0xffffffff)
blk: queue c03c0004, I/O limit 4095Mb (mask 0xffffffff)
hda: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=4865/255/63, UDMA(66)
ide-floppy driver 0.99.newide
Partition check:
hda: hda1 hda2 hda3 hda4 < hda5 hda6 >
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
NET4: Frame Diverter 0.46
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
ide-floppy driver 0.99.newide
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 3276
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 126k freed
VFS: Mounted root (ext2 filesystem).
Journalled Block Device driver loaded
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 212k freed
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 13:44:31 Sep 4 2002
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 11 for device 00:1f.2
PCI: Setting latency timer of device 00:1f.2 to 64
usb-uhci.c: USB UHCI at I/O 0xd000, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <[email protected]>
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
hub.c: USB new device connect on bus1/1, assigned device number 2
usb.c: USB device 2 (vend/prod 0x5a9/0xa511) is not claimed by any active dr
iver.
EXT3-fs warning: mounting unchecked fs, running e2fsck is recommended
EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,6), internal journal
Adding Swap: 522072k swap-space (priority -1)
Linux video capture interface: v1.00
usb.c: registered new driver ov511
ov511.c: USB OV511+ camera found
ov511.c: model: Generic Camera (no ID)
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,3), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,2), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
ov511.c: Sensor is an OV7620
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
ov511.c: Device registered on minor 0
ov511.c: v1.50 for Linux 2.4 : OV511 USB Camera Driver
parport0: PC-style at 0x378 [PCSPP,TRISTATE]
ohci1394: pci_module_init failed
ip_tables: (C) 2000-2002 Netfilter core team
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
02:0a.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xc000. Vers LK1.1.18-ac
divert: allocating divert_blk for eth0
parport0: PC-style at 0x378 [PCSPP,TRISTATE]
lp0: using parport0 (polling).
lp0: console ready
/dev/vmmon: Module vmmon: registered with major=10 minor=165 tag=$Name: buil
d-2230 $
/dev/vmmon: Module vmmon: initialized
/dev/vmnet: open called by PID 672 (vmnet-bridge)
/dev/vmnet: hub 0 does not exist, allocating memory.
/dev/vmnet: port on hub 0 successfully opened
bridge-eth0: up
bridge-eth0: attached
/dev/vmnet: open called by PID 695 (vmnet-natd)
/dev/vmnet: hub 8 does not exist, allocating memory.
/dev/vmnet: port on hub 8 successfully opened
/dev/vmnet: open called by PID 965 (vmnet-netifup)
/dev/vmnet: port on hub 8 successfully opened
divert: allocating divert_blk for vmnet8
/dev/vmnet: open called by PID 989 (vmnet-dhcpd)
/dev/vmnet: port on hub 8 successfully opened
0: nvidia: loading NVIDIA Linux x86 nvidia.o Kernel Module 1.0-4191 Mon De
c 9 11:49:01 PST 2002
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 203M
agpgart: agpgart: Detected an Intel i815, but could not find the secondary d
evice. Assuming a non-integrated video card.
agpgart: Detected Intel i815 chipset
agpgart: AGP aperture is 64M @ 0xd0000000
NET4: Linux IPX 0.47 for NET4.0
IPX Portions Copyright (c) 1995 Caldera, Inc.
IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
NET4: AppleTalk 0.18a for Linux NET4.0
/dev/vmnet: open called by PID 1463 (vmware)
bridge-eth0: set IFF_PROMISC
eth0: Setting promiscuous mode.
/dev/vmnet: port on hub 0 successfully opened
bridge-eth0: clear IFF_PROMISC
/dev/vmmon: Vmx86_ReleaseVM: unlocked pages: 72017, unlocked dirty pages: 52 961
eth0: Setting full-duplex based on MII #24 link partner capability of 41e1.
/dev/vmnet: open called by PID 1566 (vmware)
bridge-eth0: set IFF_PROMISC
eth0: Setting promiscuous mode.
/dev/vmnet: port on hub 0 successfully opened
bridge-eth0: clear IFF_PROMISC
/dev/vmmon: Vmx86_ReleaseVM: unlocked pages: 27037118, unlocked dirty pages: 15511835
/dev/vmnet: open called by PID 4084 (vmware)
bridge-eth0: set IFF_PROMISC
eth0: Setting promiscuous mode.
/dev/vmnet: port on hub 0 successfully opened
/dev/vmnet: open called by PID 4084 (vmware)
/dev/vmnet: port on hub 0 successfully opened
eth0: Setting promiscuous mode.
eth0: Setting promiscuous mode.
eth0: Setting promiscuous mode.
eth0: Setting promiscuous mode. |
|
IP卡
狗仔卡
发表于 2003-3-19 09:58:24
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡
发表于 2003-3-19 10:39:44
