请大家指导、解惑SuSE安装问题

alix_euro

在PowerPC处理器的苹果上安装SuSE 10，开始pdisk分区，照步骤安装。。。到安装boot loader这一步就不行了，总提示error，按照其官方网站提供的帮助说明选择Do not installer any boot loader，把其它四张盘装好，由于没有安装boot loader，所以系统启动不了，用CD1启动installed system后，显示屏居然出现颜色渐变，其它什么也没有，实在不解，不晓得怎么办了，我曾尝试用CD1启动install start_shell，可不知道看到的是光盘上的目录还是本地磁盘目录；按照说明，我在~/etc/目录下建立一个lilo.conf文件，照官网提供代码写入文件，但再次启动后还是如旧，显示屏颜色渐变一次，什么都没有。

请有经验的同学点拨一下，我的情况是显示配置错误还是别的什么？有什么办法能启动本地磁盘的Command line？怎么对本地磁盘进行操作？等等。

先谢谢大家了！

alix_euro

没人知道吗？请大家稍微指条路。ThX

月下刀客

可能比较少人用过PowerPC，所以。。。

我只有一条建议，试试其他发行版。。。

alix_euro

谢谢版主；我首先自己多试验，同时如果能得到大家的指正，我想绕得弯路会少一些，关于Boot Loader，有一段说明：There is currently no support to install the bootloader automatically during installation, nor is there anything to repartition your hard disk (within YaST). To workaround this, first you need to do the installation (with some special steps), then you need to reboot the installation kernel and choose to boot the installed system, and finally you need to configure the installed system.
First, during the install at the main YaST menu choose to Change Booting. Then select Boot Loader Installation and then Do not Install any Boot Loader. Continue the rest of the install until it reboots.
Once the packages are copied, the system will reboot. Since you don't have a bootloader, you need to boot off your installation kernel again (either your CD drive or network source). Once in there, boot to the linuxrc.
Inside linuxrc you can specify to boot the installed system - select option 4 (Start Installation or System) and then option 2 (Boot Installed System). Select the correct root partition and it'll boot up and continue the second stage of the install.
Note: if you previously had something installed on this system you might end up with a (to Open Firmware) bootable partition, but then no config file for yaboot. In that case you might need to select in Open Firmware where to boot.

实在不知道怎么boot至linuxrc，以及Open Firmware

getghost

我也沒玩過,友情頂上來。