求教：我编译了一个X86 linux内核有点问题？

pellxiao

我编译了一个X86（采用至强cpu 及工控主板，内存1G) linux内核，但启动报了一问题，会影响系统吗？要怎么才能解决？
启动过程如下：
Linux version 2.4.13 ([email protected]) (gcc version 2.96 20000731 (Red Hat Linux 7.1 2.96-9) #79 Fri Aug 18 10:29:00 EDT 2006
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000003fff0000 (usable)
BIOS-e820: 000000003fff0000 - 000000003fff3000 (ACPI NVS)
BIOS-e820: 000000003fff3000 - 0000000040000000 (ACPI data)
BIOS-e820: 00000000fec00000 - 0000000100000000 (reserved)
Warning only 896MB will be used.
Use a HIGHMEM enabled kernel.
On node 0 totalpages: 229376
zone(0): 4096 pages.
zone(1): 225280 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/ram0 init=/bin/init rw BOOT_IMAGE=netto
Initializing CPU#0
Detected 2400.147 MHz processor.
Calibrating delay loop... 4784.12 BogoMIPS
Memory: 897956k/917504k available (872k kernel code, 19164k reserved, 225k data, 200k init, 0k highmem)
Dentry-cache hash table entries: 131072 (order: 8, 1048576 bytes)
Inode-cache hash table entries: 65536 (order: 7, 524288 bytes)
Mount-cache hash table entries: 16384 (order: 5, 131072 bytes)
Buffer-cache hash table entries: 65536 (order: 6, 262144 bytes)
Page-cache hash table entries: 262144 (order: 8, 1048576 bytes)
CPU: L1 I cache: 12K, L1 D cache: 8K
CPU: L2 cache: 512K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: Intel(R) Xeon(TM) CPU 2.40GHz stepping 05
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfb370, last bus=7
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 2: assuming transparent
Unknown bridge resource 2: assuming transparent
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 1: assuming transparent
Unknown bridge resource 2: assuming transparent
Unknown bridge resource 2: assuming transparent
Unknown bridge resource 2: assuming transparent
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 1: assuming transparent
Unknown bridge resource 2: assuming transparent
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 1: assuming transparent
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router PIIX [8086/2480] at 00:1f.0
PCI: Found IRQ 12 for device 00:1f.1
PCI: Sharing IRQ 12 with 00:1d.2
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
keyboard: Timeout - AT keyboard not present?(ed)
keyboard: Timeout - AT keyboard not present?(f4)
Serial driver version 5.05c (2001-07-0 with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
block: 128 slots per queue, batch=16
RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086, DID=248b
PCI: Device 00:1f.1 not available because of resource collisions
PCI_IDE: chipset revision 2
PCI_IDE: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio
hdc: Flash Card, ATA DISK drive
ide1 at 0x170-0x177,0x376 on irq 15
hdc: 128256 sectors (66 MB) w/0KiB Cache, CHS=1002/4/32
Partition check:
hdc: hdc1
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 8192 buckets, 64Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 3290k freed
VFS: Mounted root (minix filesystem).
Freeing unused kernel memory: 200k freed
INIT: version 2.78 booting
proc on /proc ty hdc:pe proc (rw)
mo hdc1dprobe: modprobe
: Can't locate m hdcdule block-majo hdc1r-3
mount: /de
v/hda1 is not a valid block device
modprobe: modprobe: Can't locate module nls_cp437
modprobe: modprobe: Can't locate module nls_iso8859-1
modprobe: modprobe: Can't locate module nls_iso8859-1
/dev/hdcIntel(R) PRO/1000 Network Driver - version 7.2.7
1 on /mnt type mCopyright (c) 1999-2006 Intel Corporation.
sdos (rw)
eth0CI: Found IRQ 11 for device 02:03.0
unknown interfaPCI: Sharing IRQ 11 with 00:1d.0
ce: No such deviPCI: Sharing IRQ 11 with 02:03.1
................

INIT: Id "1" respawning too fast: disabled for 5 minutes
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
INIT: Id "2" respawning too fast: disabled for 5 minutes
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4
modprobe: modprobe: Can't locate module char-major-4


以上启动过程中：三个地方（红绿蓝）问题，请问要怎么处理？核心编译选项有遗漏？