|
我按照步骤一步一步做了
应该是做好的
内核也骗译好了
但在启动时
到了下面这一幕时
就死机了
usb.c:registered new driver usbfs
usb.c:registered new driver hub
starting kswapd
BIO:pool of 256 setup,14kb(56bytes/bio)
biover:init pool 0: 1 entries,12 bytes
biover:init pool 1: 4 entries,48 bytes
biover:init pool 2: 16 entries,192 bytes
biover:init pool 3: 64 entries,768 bytes
biover:init pool 4: 128 entries,1536 bytes
biover:init pool 5: 256 entries,3072 bytes
installing knfsd (copyright (c)1996 [email protected])
parport0:pc-style at 0x378(pcspp(,...)
pty:256 Unix98 ptys configurod
serial driver version 5.05c (2001-07-0
witn MANY_PDRTS SHARE_ERQ SERIAL_PCI IS AGNP enabled
ttys00 at 0x03f8 (irq=4)is a 16650A
ttys00 at 0x03f8 (irq=3)is a 16650A
kedundant entry in serial pci_table
please send the output of lspci -vv.
this message (1069,5459,10ao,5459)
and the manufalturer and name of serial
board or modem board
to [email protected]
reqister_serial(-):autoconfig failed
lpo:using parport 0(polling)
block:256 slots per queue.batch=32
我用的是ext2的
原来用ext3也出现这个
就死机了
为什么呢
我的RH是7.3的
升级到内核2.5.10
为什么不行呢
可不可以详尽点说呢
多谢了 |
|