|
发表于 2003-9-3 10:15:35
|
显示全部楼层
我是一个LINUX新手,高手请帮助解答几个问题,谢谢了,
唉,LINUX真不太容易搞定.
这是我的机器网卡配置图,其中无线网卡为ATMEL的eth1接口,其中有线网卡为REALTEK的eth0接口,
问题:
1:iwconfig及ifconfig两个指令有何区别?
2:我如何卸载无线网卡驱动DRIVER.
3:我如何更改接口名字,如把无线eth1改为eth0,是否可以与有线网卡名字相同(同为eth0).
以下为我机器显示结果,非常感谢.
[root@hufeng root]# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 ATMEL RFMD503A ESSID:"WALKLAN" Nickname:"WALKLAN"
Mode:Managed Channel:1 Access Point: 00:30:00:10:84:D3
Bit Rate:11Mb/s
RTS thr=2347 B Fragment thr=2346 B
Encryption keyff
Link Quality:100 Signal level:100 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@hufeng root]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:EB:08:5B:45
inet addr:192.168.12.251 Bcast:192.168.12.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1130 errors:0 dropped:0 overruns:0 frame:0
TX packets:1034 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:466632 (455.6 Kb) TX bytes:157073 (153.3 Kb)
Interrupt:10 Base address:0xb000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:6055 errors:0 dropped:0 overruns:0 frame:0
TX packets:6055 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:413613 (403.9 Kb) TX bytes:413613 (403.9 Kb) |
|