WinXP+Linux8.0安装问题

flyme

在IBM ThinkPad T40上以装好Windows XP,C:区6G,其余未分
先装Red Hat Linux 8.0.安装过程:
分区: /dev/hda1          NTFS/HPFS  6142
      /dev/hda2  /boot   ex3        103
      /dev/hda3  /       ex3        4998
     dev/hda4            Extended   23839
      /dev/hda5          swap       1026
     Free
Boot loader装在MBR上
安装完成,reboot,到选择windows XP和Linux界面.选择WindowsXP,一切正常;
选择Linux,出现:
...
PCI: Found IRQ 11 for device 00:1f.6
PCI: Sharing IRQ 11 with 00:1f.3
PCI: Sharing IRQ 11 with 00:1f.5
PCI: Sharing IRQ 11 with 02:00.1
Real Time Clock Driver v1.10e
oprofile: mapping APIC.
oprofile: no local P6 APIC. Falling back to RTC mode.
Youe CPU does not have a local APIC, e.g. mobile P6. Falling back to RTC model.
oprofile: can't get RTC I/O Ports
block: 480 slots per queue, batch=120
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for P10 modes; override with idebus=xx
PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086, DID=24ca
PCI: Device 00:1f.1 not available because of resource collisions
PCI_IDE: (ide_setup_pci_device Could not enable device.

错误在哪里?怎么解决?

chuangwaidechun

oprofile: no local P6 APIC. Falling back to RTC mode.
Youe CPU does not have a local APIC, e.g. mobile P6. Falling back to RTC model.
oprofile: can't get RTC I/O Ports

chuangwaidechun

oprofile: no local P6 APIC. Falling back to RTC mode.
Youe CPU does not have a local APIC, e.g. mobile P6. Falling back to RTC model.
oprofile: can't get RTC I/O Ports

reebird

linux内核版本太老啦

认不出也不支持Banias核心的P－M

换个新点的linux版本吧！！

flyme

I had upgrade to RT linux9, eveything is working well!